280vs lubrication.
Moderators: Martin, Steve, Mr Magoo
-
Gareth Johnston
- Posts: 2
- Joined: Fri 08 May , 2015 21:07 pm
280vs lubrication.
Hello everyone , im new to lathe work and the viceroy 280vs , im looking to know what everyone uses for oil in gearbox and saddle. Also for the greasing/oil nipples what do people use. Thanks
Re: 280vs lubrication.
I use ISO32 hydraulic oil in the headstock and gearbox on mine. On the ways I use way lube and in the oilers I use mineral engine oil.
-
Gareth Johnston
- Posts: 2
- Joined: Fri 08 May , 2015 21:07 pm
Re: 280vs lubrication.
Okay thanks Pete.
-
dazz
- CNC Expert
- Posts: 246
- Joined: Sat 19 Aug , 2006 11:31 am
- Hardware/Software: Viceroy TDS 1/1GB lathe, Imperial, stripped down and rebuilt.
Viceroy Taper/Tracer attachment, Shop made cross slide tracer attachment, VSD. - Location: New Zealand
Re: 280vs lubrication.
Hello
Hydraulic oil is a good choice for the gearbox. It's only available in 10litres drums here so I use non-EP gear oil.
EP lubricates erode yellow metals. I am about 99% certain that gearbox does not contain any bronze.
The gearbox is so lightly loaded that just about any lubricant would be OK and there would be no advantage using EP oil.
I use heavy oil for the ways. I don't use coolant so I don't have to worry about oil washing off.
I routinely wipe down the ways and apply fresh oil.
Hydraulic oil is a good choice for the gearbox. It's only available in 10litres drums here so I use non-EP gear oil.
EP lubricates erode yellow metals. I am about 99% certain that gearbox does not contain any bronze.
The gearbox is so lightly loaded that just about any lubricant would be OK and there would be no advantage using EP oil.
I use heavy oil for the ways. I don't use coolant so I don't have to worry about oil washing off.
I routinely wipe down the ways and apply fresh oil.
Regards
Dazz
Dazz