Page 1 of 1
Diameter of laser beam
Posted: Wed 14 Mar , 2007 15:43 pm
by markj
Just wondered if anybody knew the diameter of the Versalasers' laser so that we can do a contour cut in Corel and produce 'push fit' components.
Posted: Wed 14 Mar , 2007 15:59 pm
by bradders
I will ask ULS in the States for their help
Posted: Wed 14 Mar , 2007 17:10 pm
by bradders
It depends on which lens the customer is using.
The 1.5 lens has a spot size of .003
The 2.0 has a spot size of .005
Posted: Wed 14 Mar , 2007 17:50 pm
by Denford Admin
Bradders - are those sizes imperial ?
I'm guessing the spot size will be 0.005" = 0.127mm ?????
Posted: Thu 15 Mar , 2007 8:01 am
by bradders
Yes, 0.005 is in inches
HPDFO Diameter
Posted: Tue 24 Apr , 2007 18:26 pm
by ULS Service
Maybe also interesting will be the diameter of the HPDFO lens:
It is 0,002mm.
regards
Bernhard
Posted: Wed 25 Apr , 2007 9:51 am
by Denford Admin
It is 0,002mm.
With such a tiny beam, is the Versalaser resolution accurate enough to position the beam ? Or is this down to the resolution of the drawing ?
ie, If you Raster engraved an image with this size beam - would you see untouched bands between each pass ?