Print Set up

Help, advise and examples created by the Universal Laser Systems (ULS) VersaLaser laser cutting / marking machine supplied by Denford

Moderators: Martin, Steve, Mr Magoo

Post Reply
Crakkers
CNC Apprentice
CNC Apprentice
Posts: 35
Joined: Fri 01 Dec , 2006 16:35 pm

Print Set up

Post by Crakkers » Fri 01 Dec , 2006 21:14 pm

If I go to print set up in 2D Design or corel etc and ask the software to match the current printer the layout changes to a 300mm square rather than a 300 x 600 area to match the bed of the machine - why??? :( :?:
Top
User avatar
Steve
CNC Guru
CNC Guru
Posts: 1451
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Post by Steve » Sun 03 Dec , 2006 14:27 pm

This may be to do with the way the printer is set up. I assume you have a VL300?

Try going to printers in the control panel. Set the default printer to be a VL300. Go to device setup and ensure it is set to 300 x 600.

Restart the PC and try again. I am sure there are some other technical articals that will cover this.

Are you using the machine in Admin mode? If not try running in Admin and see if you get the same problem.
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Mon 04 Dec , 2006 10:51 am

I'd also recommend using the latest drivers...

https://www.denfordata.com/downloads/VL_ ... 1_28_5.zip
OR
https://www.denfordata.com/downloads/VL_ ... 1_28_5.zip

There have been problems in the past with windows not reporting the correct bed size.
Like Steve said, running the machine other than Admin (or whoever installed the driver) causes problems like this - see this other topic:
viewtopic.php?t=204
Top
Post Reply

Return to “VersaLaser”