Hi.
Could you please advise me on the minimum / recommended spec to run
Versalaser cutter.
Processor?
Ram?
HDD space?
Graphics card?
etc...
Thanks.
Paul
Computer specification for VL300/VL200 Lasers
Moderators: Martin, Steve, Mr Magoo
computer Spec
Paul,
The computer requirements are a bit vague.
You must have a computer with Windows 2000 or XP and a USB connection.
The USB driver is only available on these operating systems.
The Laser is effectivly a printer so the computer requirement is minimal but is depending on the Cad package you use.
We supply a copy of LaserCAM 2D with the Versalaser and its requirements are:
Pentium III
1GHz, 128MB RAM, 50MB Free HD, CD ROM, Floppy Drive, Open GL 3D Graphics Card with 64MB RAM supporting at least 1024 x 768
Hope this helps,
Steve
The computer requirements are a bit vague.
You must have a computer with Windows 2000 or XP and a USB connection.
The USB driver is only available on these operating systems.
The Laser is effectivly a printer so the computer requirement is minimal but is depending on the Cad package you use.
We supply a copy of LaserCAM 2D with the Versalaser and its requirements are:
Pentium III
1GHz, 128MB RAM, 50MB Free HD, CD ROM, Floppy Drive, Open GL 3D Graphics Card with 64MB RAM supporting at least 1024 x 768
Hope this helps,
Steve