INCONSISTANT VECTORING/CUTTING ACROSS THE LENGTH OF TABLE
Posted: Tue 06 Oct , 2015 11:18 am
Please can you help?
My machine is not cutting or rastering consistently. It is fine to the left side of the table, but when asked to do a job that fills the bed, cutting is no where near going through material (3mm acrylic) and etching/rastering is barely visible to the right and lower parts of the bed. I have done usual cleaning lenses/cone/reset bed etc. etc. but to no avail. I can only fear that the Laser cartridge is on its way???
Any help would be appreciated. Ta.
My machine is not cutting or rastering consistently. It is fine to the left side of the table, but when asked to do a job that fills the bed, cutting is no where near going through material (3mm acrylic) and etching/rastering is barely visible to the right and lower parts of the bed. I have done usual cleaning lenses/cone/reset bed etc. etc. but to no avail. I can only fear that the Laser cartridge is on its way???
Any help would be appreciated. Ta.