I have come accros a problem when vector engraving (blue) from TechSoft2D Ver1.25
After a period of time the axis & beam stop part way through a operation. The VersaLaser software then hangs & the computer needs to be turned off & on to regain operation.
I copied the design from 2D design & pasted it to "Word Pad"
From there I was able to print the work & run full cycle of the laser.
Versa Laser stops working & software hangs up
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
We've seen this problem before when outputting from Techsoft - its a weird one.
Use LaserCAM 2D or QuickCAM 2D instead - it never happens from these
- we put checks into QuickCAM 2D to get rid entities that could confuse the laser like: exactly duplicated lines, and lines of (very nearly) zero length etc...
Use LaserCAM 2D or QuickCAM 2D instead - it never happens from these
- we put checks into QuickCAM 2D to get rid entities that could confuse the laser like: exactly duplicated lines, and lines of (very nearly) zero length etc...