Page 1 of 1
Air pressure low
Posted: Mon 12 Apr , 2010 9:09 am
by 3d worker
Hi,
Our vera laser wont cut, a red box comes up on screen saying Air Pressure Low.
What should I do to fix it.
Many thanks
Heather
Re: Air pressure low
Posted: Mon 12 Apr , 2010 9:19 am
by bradders
What is the type of Laser and extraction unit you have ? Any serial Nos ?
Re: Air pressure low
Posted: Mon 12 Apr , 2010 9:56 am
by 3d worker
Hi
It is the Versa Laser ADVL/1
Re: Air pressure low
Posted: Mon 12 Apr , 2010 14:21 pm
by bradders
Check in the System and Diagnostic Tabs on the Versa Laser software and see if the Detect Low Air Pressure selection is checked. If it isn't then try reinstalling the software