Page 1 of 1

Laser is not penetrating the material as good as it used to

Posted: Thu 06 Jul , 2006 13:18 pm
by bradders
The Laser beam is not penetrating the material as good as it used to ?

Posted: Thu 06 Jul , 2006 13:21 pm
by bradders
Read the Laser manual for mirror and lens cleaning procedures

1. Ensure the Mirrors are clean
2. Ensure the Lens is clean
3. Ensure the Window on the Laser cartridge is clean
4. Remove any deposits from the nozzle of the air assist cone

Posted: Thu 05 Oct , 2006 19:12 pm
by Martin
Yon may also need to check the focus height. This can be done by using the manual focus tool as described in the VersaLaser manual.

Posted: Fri 06 Oct , 2006 1:08 am
by Martin
Focusing the laser beam

Auto-Z & Rotary Calibration

Posted: Fri 05 Jan , 2007 16:25 pm
by Martin
The Versalaser CPU holds all the positions & can be reset with the guide attached.
The flat metalic bed needs to be used when setting the heights.