Denford Software & Machines

Posted: **Fri 07 Nov , 2008 12:17 pm**

The Z height of our VSL3.5 is not adjusting itself automatically according to the material thickness.

I've seen references to the VCP on various sites but we don't seem to have it!

Any clues?

Posted: **Fri 07 Nov , 2008 12:35 pm**

Look on the SYSTEM tab of your Versa Laser software. In there you will find the section for auto Z to compensate for your material thickness

Denford Software & Machines

Z height not being set automatically

Z height not being set automatically