USB not communicating from PC to Versa Laser

Help, advise and examples created by the Universal Laser Systems (ULS) VersaLaser laser cutting / marking machine supplied by Denford

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

USB not communicating from PC to Versa Laser

Post by bradders » Wed 26 Apr , 2006 15:31 pm

My Versa Laser has been working fine and now I get USB not communicating from PC to Versa Laser error
Last edited by bradders on Thu 27 Apr , 2006 7:30 am, edited 1 time in total.
Top
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Post by bradders » Wed 26 Apr , 2006 15:32 pm

Make sure that the USB cable is plugged in to the same USB socket when the software was installed
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Wed 26 Apr , 2006 17:00 pm

When disconnecting or turning off the versalaser with the PC still on, it sometimes loses connection and will not find the laser again.

You are best to turn off the machine and PC, make sure everything is connected, then turn the machine back on, then let the PC find the USB connection again.
Top
Post Reply

Return to “VersaLaser”