Hi,
What are the main advantages of using the cutting table over the honeycomb table?
I mainly cut acrylic, which table is best?
Thanks
Why use the cutting table over the honeycomb table
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Why use the cutting table over the honeycomb table
The honeycomb bed is preferrable as it reduces reflections while cutting.
Becuase you get a criss-cross pattern underneath the cut edges of the acrylic, you can pack up the acrylic (eg put sheet on top of acrylic blocks) and add the extra height into the custom fixture setting.
Try and make sure the blocks are away from the tool path, and that any bits that will fall out, are also packed underneath
Becuase you get a criss-cross pattern underneath the cut edges of the acrylic, you can pack up the acrylic (eg put sheet on top of acrylic blocks) and add the extra height into the custom fixture setting.
Try and make sure the blocks are away from the tool path, and that any bits that will fall out, are also packed underneath