Hello
I have the following problem with my New Turn 270NS
no matter what program I will run automatically remains in the second embodiment , the machine in the middle of the processing of the feed are then the software must be restarted and then it runs again 1 times by the second time again the same .
if after the stop time Stop is pressed , then back to start a sentence is always executed although automatic mode is selected .
what can I do ?
New Turn 270NS is the middle of editing are
Moderators: Martin, Steve, Mr Magoo
Re: New Turn 270NS is the middle of editing are
Can you post a video of what is happening?
Can you also check you are getting spindle speed feedback on the control panel.
Can you also check you are getting spindle speed feedback on the control panel.