Pneumatic air cylinder for Triacs?
Posted: Sun 04 Aug , 2024 14:21 pm
Hi all,
back once again for a possibly silly question, but hey you seem like a nice bunch so here goes!
I have a non ATC variant of the Triac and would like to ugrade my machine to have a pneumatic drawbar like the ATC variants have.
Im aware Denford supply the drawbar and other components required to make the upgrade, but i am sure they dont supply the pneumatic cylinder for it.
i have seen the drawing for the Novamill ATC spindle (attached) and noticed that the drawing states that 63mm dia x 15 is the cylinder size required to overcome the Belville Springs and thus release the tool. my question is, will this cylinder work for the Triac? the spindle setup for the Triacs and Novamills looks identical to me but i am probably missing something,
Any help on this subject would be GREATLY appreciated.
Thank you
back once again for a possibly silly question, but hey you seem like a nice bunch so here goes!
I have a non ATC variant of the Triac and would like to ugrade my machine to have a pneumatic drawbar like the ATC variants have.
Im aware Denford supply the drawbar and other components required to make the upgrade, but i am sure they dont supply the pneumatic cylinder for it.
i have seen the drawing for the Novamill ATC spindle (attached) and noticed that the drawing states that 63mm dia x 15 is the cylinder size required to overcome the Belville Springs and thus release the tool. my question is, will this cylinder work for the Triac? the spindle setup for the Triacs and Novamills looks identical to me but i am probably missing something,
Any help on this subject would be GREATLY appreciated.
Thank you