New triac PC project

All info relating to the Denford Triac series of CNC milling machines

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
Choco
Posts: 2
Joined: Sat 09 Jan , 2021 23:51 pm

New triac PC project

Post by Choco » Sat 16 Jan , 2021 10:57 am

Hello from Ireland. I recently picked up this Denford Triac PC. The previous owner started dissembling and inspecting it. Looks like everything is there. Ball screws are free table looks in good condition etc.
My plan is to run it on Linuxcnc. I want to try and use the existing electronics and have been going through conversions done on this forum to Mach3.

Iv ordered a BOB from AliExpress and also ordered some transistors to build the little circuit to drive the original drivers.
https://a.aliexpress.com/_BPDS2P[/url]
Looking at the board it looks like it has a PWM and analog 0-10v spindle output. Will this drive the original spindle board?

Also the tools in the pic are they the easychange tools??

Denford tutor console came with it also I think they are a basic serial so would be easy enough to get working down the line.

Any tips or help would be great. This is going to be an on going project .

John
Attachments
IMG_20210116_094006.jpg
IMG_20210116_094006.jpg (473.15 KiB) Viewed 1170 times
IMG_20210116_093937.jpg
IMG_20210116_093937.jpg (305.13 KiB) Viewed 1170 times
IMG_20210116_093905.jpg
IMG_20210116_093905.jpg (424.94 KiB) Viewed 1170 times
IMG_20210116_093602.jpg
IMG_20210116_093602.jpg (370.06 KiB) Viewed 1170 times
IMG_20210116_093553.jpg
IMG_20210116_093553.jpg (209.27 KiB) Viewed 1170 times
IMG_20210116_093543.jpg
IMG_20210116_093543.jpg (229.99 KiB) Viewed 1170 times
IMG_20210116_093537.jpg
IMG_20210116_093537.jpg (311.16 KiB) Viewed 1170 times

Post Reply