Hi, The feedrate Override pot on my Fanuc Triac doesnt seem to work. I have put an m49 in the beginning of my program to ensure that any M48 is cancelled but still does full feed regardless. Anyone know how I can check if the Pot is working?
Also I can copy Z position straight into the tool offset page with the EOB button, but does anyone know if I can also copy postion data straight into a program for example a G92 position?
Triac Feed-rate Override Pot
Moderators: Martin, Steve, Mr Magoo
-
jamesgates1000
- CNC Apprentice
- Posts: 89
- Joined: Sat 01 Aug , 2015 9:23 am
- Hardware/Software: 2001 Cyclone with toolchanger and Fanuc 21i control
Serial number - H00913.
Voltage 415V F.L.C 20A 50Hz 3Ph
1997 Triac VMCwith toolchanger and Fanuc O-M control
Serial number - 70826B.
Voltage 415V F.L.C 30A 50Hz 3Ph