CNC Expert
I'm looking at replacing the x axis ballscrew does anyone know of direct replacement part.
CNC Expert
Oh, I didn't realise you could get them reballed,....
I assume that is alot cheaper than a new one.
But that is the issue, quite a while ago I stripped the machine down and lost a few ball bearings from the x axis ball nut, recently it has been, almost like snapping in the axis, at certain points, and wondered whether the ball screw was now playing up due to the loss of bearings, I haven't got round to stripping it down yet, but that is my plan over the Xmas hols. Where did you get them re balled?
I assume that is alot cheaper than a new one.But that is the issue, quite a while ago I stripped the machine down and lost a few ball bearings from the x axis ball nut, recently it has been, almost like snapping in the axis, at certain points, and wondered whether the ball screw was now playing up due to the loss of bearings, I haven't got round to stripping it down yet, but that is my plan over the Xmas hols. Where did you get them re balled?