Page 1 of 1
triac spindle motor (servo)
Posted: Wed 07 Nov , 2012 22:40 pm
by comet
Hi I have updated my triac with later steppers/drivers also mach 3.
The machine has the servo type spindle motor,
I would like to control it passively with just a switch and a pot for now,how do I do that?
is there any electronics schematics available?
cheers
tony
Re: triac spindle motor (servo)
Posted: Thu 08 Nov , 2012 1:44 am
by Martin
What drive does the Triac have?
Re: triac spindle motor (servo)
Posted: Thu 08 Nov , 2012 9:13 am
by comet
not sure havnt pulled the tray out yet only got the machine yesterday ill post back later with the details.
for now serial number tr14039f built may 89
Tony
Re: triac spindle motor (servo)
Posted: Thu 08 Nov , 2012 10:59 am
by Denford Admin
Re: triac spindle motor (servo)
Posted: Thu 08 Nov , 2012 19:02 pm
by comet
No its a linx 80, is that good or bad?
Tony
Re: triac spindle motor (servo)
Posted: Thu 08 Nov , 2012 20:39 pm
by comet
Ok found the manual it all looks straight forward,hope it works,as i havnt put power to it yet.
if not Ive got a eurotherm 508 that should do the job.
is there any market for all the original triac electronics? as im mach3ing this with new steppers and drivers?
Tony
Re: triac spindle motor (servo)
Posted: Thu 08 Nov , 2012 23:33 pm
by angel-tech
i may be interested in the drivers and psu, and the steppers.
Re: triac spindle motor (servo)
Posted: Fri 09 Nov , 2012 9:37 am
by comet
Angel,
Im in worcester,whereabouts are you?
Re: triac spindle motor (servo)
Posted: Fri 09 Nov , 2012 10:14 am
by angel-tech
sunny Cardiff
Re: triac spindle motor (servo)
Posted: Fri 09 Nov , 2012 10:39 am
by comet
Ok what bits exactly do you want?
Re: triac spindle motor (servo)
Posted: Fri 09 Nov , 2012 10:44 am
by angel-tech
stepper drivers, steppers, stepper power supply. Which stepper drivers are they, sd2/3 i expect.
Re: triac spindle motor (servo)
Posted: Fri 09 Nov , 2012 10:56 am
by comet
ive got 3 drives and the xand y steppers no z stepper
steppers are mae? I assume it all works when you power up the base the screen comes on with no error messages?
Tony
Re: triac spindle motor (servo)
Posted: Fri 09 Nov , 2012 11:04 am
by angel-tech
i'm off to manchester sunday, would it be possible to pop in on the way home.
Re: triac spindle motor (servo)
Posted: Fri 09 Nov , 2012 23:06 pm
by comet
sure,but to be honest id rather you take the lot with you,ie the tray with everything minus the motor controller,which works!!
make me an offer i cant refuse! as it will save me ebaying it all can you pm me?
tony
Re: triac spindle motor (servo)
Posted: Fri 09 Nov , 2012 23:22 pm
by angel-tech
i'm happy to take the whole lot minus the inverter..
I'll pm you my number so we can have a chat.