max weight of vise

[mickgc29]

Hi there

i have a denford triac and will start to use it soon as i have been saving up for a three phase inverter

i got a kurt dl430 vise for the m/c a few months ago but i have been told it will be to heavy for the m/c

does any body know the max weight i can put on the milling table please

cheers Mick

[Denford Admin]

It's pretty difficult to quantify - you can probably put a lot of weight on a Triac table, however, it will just stall the stepper motors when you try to move it.
Then, if they did move the weight, they might still stall when taking a cut, due to the extra load.

[angel-tech]

i've seen triacs with a 4" vertex vice as standard. i can weigh the one i have here if it helps.

[angel-tech]

Also they've had the hydrahlic vice option, i'll weigh that for you as well if you need it.

[mickgc29]

Hi Angletech

could you please weigh the vise you have mine as servo not steppers but should be the same power one would think

the vise i got for the mill is a kurt DL430 and is 45pounds in weigh looking at a other vise that is 24 pounds in weigh

thank you
mick

[angel-tech]

i'll dig them out in the morning and weigh them. The hydrahlic vice is from a servo machine.