Denford Software & Machines

Hi looking at the spindle drawings for non atc triacs there are 3 bearings shown, 2 angular contact and one other ball bearing.
Does anybody know what number bearings they are as I would like to replace mine but dont want to strip the machine until I get the new ones, thanks Rich.

They non-atc and atc are the same bearings and are shown here:
viewtopic.php?f=15&t=1953&p=6689#p6689

Thankyou, thats great. Rich.

I've seen the quill section drawing before on the forum and it shows 3 bearings. My Triac, despatch date June 1995, would seem to have only the lower 2 bearings as the quill stops just above the timing pulley. I've not seen that arrangement shown in any drawings on the forum.