Page 1 of 1
Triac VMC
Posted: Tue 17 May , 2011 15:36 pm
by cdmodelz
I recently purchased a Triac VMC converted to Mach 3 with an 8 station auto tool changer
https://www.youtube.com/watch?v=9fdW6Icd ... Tzx_yKtSnU
Re: Triac VMC
Posted: Wed 18 May , 2011 9:08 am
by Denford Admin
Not bad at all !
Although, dare I say that the new machine (VMC1300) contours a bit quicker
https://www.youtube.com/watch?v=YAmnjtRxb_A
Re: Triac VMC
Posted: Fri 20 May , 2011 15:38 pm
by cdmodelz
It was doing around 50mm/min in the video. I couldn't machine much quicker as the part was only held with double sided tape. I reckon it could easily do 1.2m/min if the block was in the vice.
Notice also the toolchanger has been raised 30mm for extra clearance when changing tools. I am getting another VMC in a few weeks as I am very impressed with it.
The spindle is exceptionally quiet in operation.
Re: Triac VMC
Posted: Sun 22 May , 2011 20:10 pm
by angel-tech
Looking good....
