Triac Ball Screws turns per inch

All info relating to the Denford Triac series of CNC milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
mbrooks
Posts: 3
Joined: Sun 25 Jun , 2006 2:50 am

Triac Ball Screws turns per inch

Post by mbrooks » Tue 01 Aug , 2006 1:37 am

Hello,
How many turns per inch are the ball screws in a Triac VMC?
Are all the ball screws the same?
Thanks,
Mike :?:
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Tue 01 Aug , 2006 12:27 pm

Hi,

It will be a 5mm pitch ballscrew
The motor to ballscrew drive ratio will be 2.5 to 1

Hope this helps
Top
Post Reply

Return to “Triac”