Denford Software & Machines

Posted: **Fri 09 Apr , 2010 11:41 am**

Hi
I am looking for someone who can convert/update my old Triac to run on Mach 3 or similar software etc ?, if there is anyone who can, then how much will this cost, the machine is in Leeds.
Cheer's

Bob.
bobnclaire08@yahoo.co.uk

tel #- 07501117763

Posted: **Fri 09 Apr , 2010 11:53 am**

Bob,

I am not sure what you are trying to get out of the upgrade or what control electronics you currently have?

Denford would be able to convert most triacs to run from USB and have continuous path manufacturing capabillity which would speed up programs.

There are quite a few advantages to running the latest VR Milling 5 these are covered in the attached link:

viewtopic.php?f=2&t=101

What software are you currently using?

Is the machine in working order?

Denford Software & Machines

Is there anyone out there who can convert my Triac ?

Is there anyone out there who can convert my Triac ?

Re: Is there anyone out there who can convert my Triac ?