Hi
I am looking for someone who can convert/update my old Triac to run on Mach 3 or similar software etc ?, if there is anyone who can, then how much will this cost, the machine is in Leeds.
Cheer's
Bob.
bobnclaire08@yahoo.co.uk
tel #- 07501117763
Is there anyone out there who can convert my Triac ?
Moderators: Martin, Steve, Mr Magoo
-
sopysnipe01
- Posts: 16
- Joined: Wed 10 Feb , 2010 15:45 pm
Re: Is there anyone out there who can convert my Triac ?
Bob,
I am not sure what you are trying to get out of the upgrade or what control electronics you currently have?
Denford would be able to convert most triacs to run from USB and have continuous path manufacturing capabillity which would speed up programs.
There are quite a few advantages to running the latest VR Milling 5 these are covered in the attached link:
viewtopic.php?f=2&t=101
What software are you currently using?
Is the machine in working order?
I am not sure what you are trying to get out of the upgrade or what control electronics you currently have?
Denford would be able to convert most triacs to run from USB and have continuous path manufacturing capabillity which would speed up programs.
There are quite a few advantages to running the latest VR Milling 5 these are covered in the attached link:
viewtopic.php?f=2&t=101
What software are you currently using?
Is the machine in working order?