Denford Software & Machines

Hello Help needed.

I’m currently working on a Triac VMC MILLER which has been upgraded to VME and using the VR CNC Milling software. Unfortunately, the software was reinstalled on the laptop because of sharing with a CNC router machine and now the 8 station carousel is out of sink with the tool library. I have tried toggling the carousal cw & ccw in the jog mode to bring back each tool highlighted in green but nothing seems to store etc. Does any one know any tricks to fix the problem? Thanks in anticipation.

I think it's M27 that sets current tool to number 1 .. it's in the manual I believe if it's not M27 it's very close
best I can do from the old grey matter

It is M27.

You will need to index first to position 1 then execute a M27.

Thanks for confirming that my old grey matter still works Martin!