Denford Software & Machines

I have purchased a Triac VMC I can run a program dripfeed if it is on the internal hard disk and I have managed to send and recieve programs to and from another pc via a RS232 cable. Is it possible to run a program dripfeed from the external PC? If so how do I get the mill in dripfeed mode to accept/run the program?

Triac VMC
Serial no. 50809A
Year 1995
Software Fanuc 2.88

Many thanks in advance
Nick

This guy has previously had drip feed working on (I'm guessing) a similar machine:
viewtopic.php?f=4&t=1107
Maybe you could PM (Private message) him if it's the same setup as yours.

This other post may also help:
viewtopic.php?t=756