Hi,
I am wondering if anyone has ever been able to get a third party DNC software program to work with a Denford Triac Mill. The Mill is from 1992 and has a northeast Electronics PNC-3 control. If you have could you share with me the name of the program and what settings were necessary for it to communicate.
Thanks
DNC For Triac
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Thank You for the reply.
I saw that posted in the forum and understand that the PNC-3 controler uses it's receive pin as a busy line.
I haven't tried Teraterm as an option though.
What I have been trying is third party DNC Software such as Cadem's NCnet, ProNC, DNC Precision, Easy DNC and so forth. My ultimate goal and reason for looking in this direction is to be able to drip feed this machine in order to get past the 750 line limit to the size of my programs.
Any ideas are appreciated.
Thanks again
I saw that posted in the forum and understand that the PNC-3 controler uses it's receive pin as a busy line.
I haven't tried Teraterm as an option though.
What I have been trying is third party DNC Software such as Cadem's NCnet, ProNC, DNC Precision, Easy DNC and so forth. My ultimate goal and reason for looking in this direction is to be able to drip feed this machine in order to get past the 750 line limit to the size of my programs.
Any ideas are appreciated.
Thanks again
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact: