Page 1 of 1
Fanuc 21i user manual wanted
Posted: Wed 17 Dec , 2008 17:00 pm
by Tony Pike
Hi does any one have a copy for a Fanuc 21i user manual for a 1999
TRIAC mill with atc
Thanks Tony
Posted: Thu 18 Dec , 2008 17:56 pm
by Denford Admin
Am sure we have some on pdf - will have a look tomorrow for you
Thanks
Posted: Thu 18 Dec , 2008 18:52 pm
by Tony Pike
The book would be very usefull
Thanks Tony
Posted: Thu 18 Dec , 2008 20:05 pm
by Steve
I think there is a tight copyright on these so we would be unable to scan it for you.
I am sure you could buy from GE Fanuc
Posted: Sat 20 Dec , 2008 22:54 pm
by Lone_Ranger
.
Plenty available on US Ebay, just do a search or try this one on a "Buy it now".
https://cgi.ebay.co.uk/GE-FANUC-SERIES-1 ... .m63.l1177
Regards
Rob
.
Posted: Mon 22 Dec , 2008 9:54 am
by Denford Admin
Before forking out too much on manuals, make sure its the right one for you. This one on ebay looks like a Maintenance manual, which will not tell you anything about programming or operating the Fanuc..but will help with the connections and parameter settings.
There are connection manuals which go into detailed control / drive / spindle connections, installation and commissioning.
There are operator manuals which concentrate more on using the control.
Then there are the CNC programming manuals.
Oh and a whole host of manuals for things like FAPT, PMC ladder, spindle drive setup etc...etc..