Page 1 of 1
Triac RS232 lead - Pin layout?
Posted: Mon 08 Dec , 2008 12:38 pm
by Grant_robochallenge
Hi, I am trying to run my 1984-5 Triac via BobCad/Cam on my PC but I do not have the required RS232 cable.
I have bought the connectors to make up a lead, and I am unsure of the pin layout.
Any one have any idea?
Thankyou
rs232 pinout
Posted: Mon 08 Dec , 2008 12:54 pm
by Andycnc
from the orac manual (should be the same as triac)
data
Posted: Mon 08 Dec , 2008 12:58 pm
by Andycnc
try also
https://www.denfordata.com/downloads/dos/triac.zip
this may help testing your 232 connection.
You may also find the manuals for the triac here, though I've not checked.
Posted: Mon 08 Dec , 2008 16:01 pm
by Grant_robochallenge
Hi Andy, thankyou for that info - but on the Triac it is a 7 pin DIN connector, and not the same as the Orac sadly.
Although I could have done with that info you gave me for a freinds Orac
triac 232
Posted: Mon 08 Dec , 2008 17:09 pm
by Andycnc
sorry for the missleading info!
In the manuals dowload section is the scanned manual for the triac- there are connection details there
https://www.denfordata.com/downloads/dos/manuals.zip
Posted: Tue 09 Dec , 2008 17:05 pm
by Grant_robochallenge
Thank you very much Andy - I think I've found what im looking for from your link.
Regards