Denford Software & Machines

Posted: **Fri 17 Oct , 2008 15:43 pm**

Can anyone tell me if the 1991 Triac with the tool changer is BT30 taper or if not what taper it is?
Thanks in advance,
Charles

Posted: **Fri 17 Oct , 2008 16:03 pm**

regnilham wrote:Can anyone tell me if the 1991 Triac with the tool changer is BT30 taper or if not what taper it is?
Thanks in advance,
Charles

Not 100% sure but I seem to remember that the 6 position ATC was BT35 and the 8 position ATC was BT30.

Regards
Rob

Posted: **Fri 17 Oct , 2008 22:32 pm**

The spindle taper is BT 30

The manual toolchanger is the easychange. (EC)

Posted: **Sat 18 Oct , 2008 16:25 pm**

Thanks for the replys. I found a website that gives the taper dimensions and measured my one toolholder (came with the machine) and it appears that it is in fact BT35 taper. I can now order the proper toolholders.
Thanks again,
Charles

Denford Software & Machines

1991 Denford Triac taper.

1991 Denford Triac taper.

Re: 1991 Denford Triac taper.

1991 Triac taper.