Drive card for Triac PC?

All info relating to the Denford Triac series of CNC milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
ChrisMW
Posts: 1
Joined: Fri 22 Aug , 2008 14:28 pm

Drive card for Triac PC?

Post by ChrisMW » Fri 22 Aug , 2008 16:36 pm

Hi All,

Does anyone know if its possible to obtain a electrical schematic for a SD12 drive card for a Triac PC? Think a fault has developed in the x axis drive card :(

I have searched the forum and the internet but havent come across one.

Any assistance would be great!!!

Thanks,

Chris
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Fri 29 Aug , 2008 18:23 pm

Not sure if we have any schematics, but I seem to remember someone else fixing theirs by pulling out, cleaning and pushing back in the chips that were socketed - maybe worth a try.
Top
Post Reply

Return to “Triac”