Triac 1988

All info relating to the Denford Triac series of CNC milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
nthorpey
Posts: 4
Joined: Mon 06 Mar , 2006 21:57 pm
Contact:
Contact nthorpey

Triac 1988

Post by nthorpey » Mon 24 Apr , 2006 20:22 pm

Hi all, just purchased a triac for a few hobby parts

Its from 11/1988.

Serial is either 354 or 554 just cant quite see it

Some pics here of it.

Image

Image

Image



https://smg.photobucket.com/albums/0603/nthorpey/TRIAC/


Also I need a full list of G codes that this machine/control uses to write a post for it.

What is the serial wiring and connector type/part i need to allow me to transfer programs from my pc to the machine.

Many thanks in advance

Nick
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Tue 25 Apr , 2006 10:15 am

Have a look at the thread "Orac serial connection" - I believe the Orac would be the same vintage hardware as your Triac.

Also see whats on our website (technical support) to download for the older machines (look under DOS software - no longer supported)
https://www.denford.co.uk/technical-support.asp
Top
User avatar
Mr Magoo
CNC Guru
CNC Guru
Posts: 301
Joined: Tue 21 Feb , 2006 21:45 pm
Location: Brisbane, Australia

Post by Mr Magoo » Tue 25 Apr , 2006 21:31 pm

Take a look at the "Triac Data link" post in this forum too.

And I think the Manuals.ZIP file you can download from the Denford website contains info on the Triac PNC3 serial connector and Data format the machine expects to receive
Top
Post Reply

Return to “Triac”