Upgrades for Older Triac PC w/AT
Posted: Mon 25 Feb , 2008 22:07 pm
I have a Triac PC with an eight station tool changer and would like to know if there are any upgrades that would work with this machine. It was purchased 3/96. Ser. # EO4723. I use Inventor 11 software to create the part/mold and then import it into MasterCam X to set the tool paths and create the NC code. I upgraded the CNC tutor mill control in 2001. I have been browsing this forum and noticed discussion about stepper performance and replacing the conrol card. I have had a few jobs that my students were running and all of a sudden the machine goes haywire and starts cutting in its own way, destroying the project. Any information would be greatly appreciated.