I have purchased a Triac VMC I can run a program dripfeed if it is on the internal hard disk and I have managed to send and recieve programs to and from another pc via a RS232 cable. Is it possible to run a program dripfeed from the external PC? If so how do I get the mill in dripfeed mode to accept/run the program?
Triac VMC
Serial no. 50809A
Year 1995
Software Fanuc 2.88
Many thanks in advance
Nick
Dripfeeding
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Dripfeeding
This guy has previously had drip feed working on (I'm guessing) a similar machine:
viewtopic.php?f=4&t=1107
Maybe you could PM (Private message) him if it's the same setup as yours.
This other post may also help:
viewtopic.php?t=756
viewtopic.php?f=4&t=1107
Maybe you could PM (Private message) him if it's the same setup as yours.
This other post may also help:
viewtopic.php?t=756