Fanuc 21i user manual wanted

All info relating to the Denford Triac series of CNC milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
Tony Pike
Posts: 7
Joined: Tue 16 Dec , 2008 14:37 pm

Fanuc 21i user manual wanted

Post by Tony Pike » Wed 17 Dec , 2008 17:00 pm

Hi does any one have a copy for a Fanuc 21i user manual for a 1999
TRIAC mill with atc

Thanks Tony
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Thu 18 Dec , 2008 17:56 pm

Am sure we have some on pdf - will have a look tomorrow for you
Top
Tony Pike
Posts: 7
Joined: Tue 16 Dec , 2008 14:37 pm

Thanks

Post by Tony Pike » Thu 18 Dec , 2008 18:52 pm

The book would be very usefull

Thanks Tony
Top
User avatar
Steve
CNC Guru
CNC Guru
Posts: 1451
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Post by Steve » Thu 18 Dec , 2008 20:05 pm

I think there is a tight copyright on these so we would be unable to scan it for you.

I am sure you could buy from GE Fanuc
Top
User avatar
Lone_Ranger
CNC Expert
CNC Expert
Posts: 221
Joined: Mon 01 Oct , 2007 15:23 pm
Contact:
Contact Lone_Ranger

Post by Lone_Ranger » Sat 20 Dec , 2008 22:54 pm

.

Plenty available on US Ebay, just do a search or try this one on a "Buy it now".

https://cgi.ebay.co.uk/GE-FANUC-SERIES-1 ... .m63.l1177

Regards
Rob

.
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Mon 22 Dec , 2008 9:54 am

Before forking out too much on manuals, make sure its the right one for you. This one on ebay looks like a Maintenance manual, which will not tell you anything about programming or operating the Fanuc..but will help with the connections and parameter settings.
There are connection manuals which go into detailed control / drive / spindle connections, installation and commissioning.
There are operator manuals which concentrate more on using the control.
Then there are the CNC programming manuals.
Oh and a whole host of manuals for things like FAPT, PMC ladder, spindle drive setup etc...etc..
Top
Post Reply

Return to “Triac”