can i use fanuc md to run my 2000 triac pc

All info relating to the Denford Triac series of CNC milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
-=PAB=-
CNC Apprentice
CNC Apprentice
Posts: 82
Joined: Mon 19 Jun , 2006 19:46 pm

can i use fanuc md to run my 2000 triac pc

Post by -=PAB=- » Sat 16 Aug , 2008 20:42 pm

as the topic says- need some control software to run my 2000 triac pc wondered if fanuc.md will operate it ok and do i need an activation key?
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Mon 18 Aug , 2008 8:43 am

You would need to have a Mint 3.28 eprom fitted to the top board (this may possibly be still with the machine if its had an upgrade to VR2?)

The DOS software flash codes are available for free from the website:
https://www.denford.ltd.uk/index.php?opt ... &Itemid=51
Top
Post Reply

Return to “Triac”