Proximity sensors

All info relating to the Denford Triac series of CNC milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
RNR107
CNC Apprentice
CNC Apprentice
Posts: 42
Joined: Mon 21 Feb , 2011 9:22 am
Hardware/Software: TRIAC, ORAC, Mach3
Location: West Yorshire

Proximity sensors

Post by RNR107 » Sun 12 Aug , 2012 18:03 pm

Hi all,
I bought a Denford Triac in need of re-wiring. It is a green one with steppers made in 1985.
I managed to get the Spindle controller and steppers working fine, but I am stuck on the proximity sensors on each axis.
What are these ? how do they wire ?
They looks like a 20mm long threaded bar of 6mm diameter with a black and a blue wire coming of the back.

Any help would be greatly appreciated...

Laurent
Top
Martin
CNC Guru
CNC Guru
Posts: 1916
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Proximity sensors

Post by Martin » Mon 13 Aug , 2012 6:52 am

Hi,

Have a look at the following post.


viewtopic.php?t=2621
Top
RNR107
CNC Apprentice
CNC Apprentice
Posts: 42
Joined: Mon 21 Feb , 2011 9:22 am
Hardware/Software: TRIAC, ORAC, Mach3
Location: West Yorshire

Re: Proximity sensors

Post by RNR107 » Mon 13 Aug , 2012 7:54 am

Thank you. But all links to the datasheet are broken... :(
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Re: Proximity sensors

Post by Denford Admin » Mon 13 Aug , 2012 15:24 pm

This other post has the datasheet
viewtopic.php?f=13&t=2932
Top
Post Reply

Return to “Triac”