parts lists, bearings

All info relating to the Denford Triac series of CNC milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
ricky b
Posts: 9
Joined: Thu 15 Oct , 2009 15:44 pm

parts lists, bearings

Post by ricky b » Tue 07 Jun , 2011 10:24 am

Hi looking at the spindle drawings for non atc triacs there are 3 bearings shown, 2 angular contact and one other ball bearing.
Does anybody know what number bearings they are as I would like to replace mine but dont want to strip the machine until I get the new ones, thanks Rich.
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Re: parts lists, bearings

Post by Denford Admin » Tue 07 Jun , 2011 13:48 pm

They non-atc and atc are the same bearings and are shown here:
viewtopic.php?f=15&t=1953&p=6689#p6689
Top
ricky b
Posts: 9
Joined: Thu 15 Oct , 2009 15:44 pm

Re: parts lists, bearings

Post by ricky b » Wed 08 Jun , 2011 9:41 am

Thankyou, thats great. Rich.
Top
DavidB
CNC Expert
CNC Expert
Posts: 178
Joined: Tue 19 Oct , 2010 16:06 pm
Hardware/Software: Triac, Orac

Re: parts lists, bearings

Post by DavidB » Wed 08 Jun , 2011 12:43 pm

I've seen the quill section drawing before on the forum and it shows 3 bearings. My Triac, despatch date June 1995, would seem to have only the lower 2 bearings as the quill stops just above the timing pulley. I've not seen that arrangement shown in any drawings on the forum.
Top
Post Reply

Return to “Triac”