I recently purchased a Triac VMC converted to Mach 3 with an 8 station auto tool changer
https://www.youtube.com/watch?v=9fdW6Icd ... Tzx_yKtSnU
Triac VMC
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Triac VMC
Not bad at all !
Although, dare I say that the new machine (VMC1300) contours a bit quicker
https://www.youtube.com/watch?v=YAmnjtRxb_A
Although, dare I say that the new machine (VMC1300) contours a bit quicker
https://www.youtube.com/watch?v=YAmnjtRxb_A
Re: Triac VMC
It was doing around 50mm/min in the video. I couldn't machine much quicker as the part was only held with double sided tape. I reckon it could easily do 1.2m/min if the block was in the vice.
Notice also the toolchanger has been raised 30mm for extra clearance when changing tools. I am getting another VMC in a few weeks as I am very impressed with it.
The spindle is exceptionally quiet in operation.
Notice also the toolchanger has been raised 30mm for extra clearance when changing tools. I am getting another VMC in a few weeks as I am very impressed with it.
The spindle is exceptionally quiet in operation.
-
angel-tech
- CNC Guru
- Posts: 525
- Joined: Tue 14 Nov , 2006 12:12 pm
- Hardware/Software: .....
4 Quatros
3 Oracs
2 Easiturn atc
12 station lathe atc
Mach 3 - Location: Quatroland
Re: Triac VMC
Looking good.... 