Page 1 of 1
StarTurn image gallery
Posted: Fri 29 Jan , 2010 15:52 pm
by Denford Admin
StarTurn image gallery
Re: StarTurn image gallery
Posted: Tue 23 Feb , 2010 2:42 am
by beeman
Do you have any photos of a Starturn PC, or any info on these. I have just bought one but not yet collected it. It has lathe cam designer 1.1 and it says it comes with "Starturn PC Software Version 2.23" I can find no mention of this on the forums was this similar to VR Turning?. It is a slant bed similar to a novaturn but with a square case.
Kind regards
John
Re: StarTurn image gallery
Posted: Tue 23 Feb , 2010 10:13 am
by Denford Admin
The bottom 2 links will be relevant manuals to the software that will run your machine:
DOS machine software PLUS Photos and Drawings:
viewtopic.php?t=196
Dos Software free downloads:
http://www.denford.ltd.uk/index.php?opt ... &Itemid=51
Starturn problems:
viewtopic.php?t=1113
Dosbox:
viewtopic.php?t=844
Fanuc OT offline turning Programming manual DOS version PDF:
viewtopic.php?f=15&t=2324
DOS Turning Software Manual:
viewtopic.php?f=15&t=953
Re: StarTurn image gallery
Posted: Wed 23 Mar , 2011 13:27 pm
by Denford Admin
This is the Starturn 5 (ST5) where the Novaturn used to be known as the Starturn 6
(How the obviously older Starturn 4 and 8 fit in I don't know
)
Re: StarTurn image gallery
Posted: Wed 09 May , 2012 13:17 pm
by Denford Admin
Starturn 8 with BBC micro