Page 1 of 1
StarMill circa 1989
Posted: Mon 05 Feb , 2007 17:13 pm
by davisa
Is it possible to drip feed to this machine. We have just found this Starmill a few days ago and would like to get it moving. A manual would be useful
A picture has been added.
Posted: Tue 06 Feb , 2007 9:53 am
by Denford Admin
I think there are different control version of these - a photo of the electronics would help.
I've found a NEE version and a Baldor / DOS version (these ones should be able to be upgraded to run the latest windows software)
Posted: Tue 06 Feb , 2007 19:10 pm
by Mr Magoo
This is an NEE version of the Starmill (fitted with an SMCU controller)
It must be connected to a PC to enter and run CNC programs (you can not program the machine from the front panel, only jog it around)
Software and cable diagrams can be found here
viewtopic.php?t=196 - use the "Starmill SMCU" software in the zip!