Starmill ATC - security key not connected

All info relating to the Denford Starmill CNC milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
jai
Posts: 6
Joined: Wed 10 Jul , 2013 21:04 pm
Hardware/Software: Starmill ATC circa 1990
software - v2.1a

Starmill ATC - security key not connected

Post by jai » Wed 10 Jul , 2013 22:11 pm

Machine is circa 1990. Runs on DOS. Starmill.EXE starts on boot.

Errors out with "Security Key not Connected"

Dont think this is a physical key.

Any help will be appreciated. I eventually want to upgrade to VR Milling also run the software from another machine - say XP. Have been reading lots of posts here (forum is very helpful), but not sure whether this entails hardware upgrade as well.

Thanks.

Jai

jai
Posts: 6
Joined: Wed 10 Jul , 2013 21:04 pm
Hardware/Software: Starmill ATC circa 1990
software - v2.1a

Re: Starmill ATC - security key not connected

Post by jai » Mon 15 Jul , 2013 21:11 pm

ok. got this to work. there were some issues with the location of the opt file.

andy_con
CNC Expert
CNC Expert
Posts: 190
Joined: Fri 05 Oct , 2012 20:06 pm
Hardware/Software: Triac Vmc with 6 station ATC
Starmills with ATC

Re: Starmill ATC - security key not connected

Post by andy_con » Wed 17 Jul , 2013 22:49 pm

starmill with atc... nice, got any pics?

jai
Posts: 6
Joined: Wed 10 Jul , 2013 21:04 pm
Hardware/Software: Starmill ATC circa 1990
software - v2.1a

Re: Starmill ATC - security key not connected

Post by jai » Thu 18 Jul , 2013 18:32 pm

you can find the photos here
viewtopic.php?f=45&t=4241&p=16722#p16722

Post Reply