Starmill Rebuild
Posted: Tue 30 Aug , 2011 15:12 pm
I’m rebuilding a 1990 vintage starmill that came my way without any electrics other than the stepper motors and spindle motor. The plan is to fit the mill with new power supply and drivers to run Mach 3.
The stepper motors are MAE HY 200-3424-310-A8 and MAE HY 200-2220-210-A8, looking for the voltage and amp’s for these.
I’m also looking for the pitch of the x, y & z ballscrews.
Simon
The stepper motors are MAE HY 200-3424-310-A8 and MAE HY 200-2220-210-A8, looking for the voltage and amp’s for these.
I’m also looking for the pitch of the x, y & z ballscrews.
Simon