I was just wondering if anyone knows what diameter the spindle pulley bore is and the keyway size is?
Looking to put a taper lock HTD pulley on it with a servo motor to upgrade an indexing spindle.
Thanks,
Rob
Orac Spindle Pulley Bore + Keyway size
Moderators: Martin, Steve, Mr Magoo
-
robertspark
- Posts: 8
- Joined: Fri 27 Jul , 2018 19:59 pm
- Hardware/Software: Orac / Mach4 / UCCNC
- Location: nr Liverpool
Orac Spindle Pulley Bore + Keyway size
Rob
Einstein ― “If you can't explain it to a six year old, you don't understand it yourself”
...working my way through the 1000+ ways things don't work to find the one that does
Einstein ― “If you can't explain it to a six year old, you don't understand it yourself”
...working my way through the 1000+ ways things don't work to find the one that does
-
robertspark
- Posts: 8
- Joined: Fri 27 Jul , 2018 19:59 pm
- Hardware/Software: Orac / Mach4 / UCCNC
- Location: nr Liverpool
Re: Orac Spindle Pulley Bore + Keyway size
Spindle pulley is 30mm dia, keyway is ~8mm wide and ~3mm deep (into the pulley)
Spindle pulley is ~61.7mm dia
Motor pulley is ~ 34.7mm dia
Pulley ratio is therefore ~ 1.778:1
Spindle pulley is ~61.7mm dia
Motor pulley is ~ 34.7mm dia
Pulley ratio is therefore ~ 1.778:1
Rob
Einstein ― “If you can't explain it to a six year old, you don't understand it yourself”
...working my way through the 1000+ ways things don't work to find the one that does
Einstein ― “If you can't explain it to a six year old, you don't understand it yourself”
...working my way through the 1000+ ways things don't work to find the one that does