controllers
Posted: Sat 21 Sep , 2013 8:49 am
Well iv had a look at what is a vaialbe and i may be leaning towards replacing everything. Has anyone used a SYSTEM4X PACKAGE from DIYCNC? from what i can see the only drawback is the lack of power these units have, they are built with 50v drivers but only a 36v power supply and im sure the orac steppers can run up to 90v!
If anyone has used one of these systems on their lathe could you please contact me.
Thanks!
If anyone has used one of these systems on their lathe could you please contact me.
Thanks!