Denford Software & Machines

hi
i own an orac seriel number AC15015Z FEB 85.
my problem is that all works fine except the spindle drive
in manual and auto modes. all fuses are ok. i suspect there is )
no power gettingto the inverter, 1 of the circuit boards has an unlit LED,
far right, seriel number of circuit board is 58011512 P.
can anyone shed light on a why this LED is not lit. regards baz.

ps if i could figure out how to load a piccy of the board i would again help reqd.

Sounds simple but have you checked the emergency stop circuit and the X and Z limit switches ?

To load a picture use Choose File button in the Upload attachment section immediately below where you enter the message, open the Folder on your computer that contains the image you want to upload and highlight it with a click, file then uploads to the site.
Best to make sure your image is set to email size or the system may not allow it to upload because of it's size.

Emgee

hi
the em stop is ok i can get axis movement but no spindle drive.