Page 1 of 1
Orac 84 lathe PC to CNC
Posted: Tue 21 Aug , 2007 13:25 pm
by Eugene Kruger
Hi I have a Orac 84 lathe, I would like to convert it to run from a PC. Were can I get a step by step guide, from start to scratch? If pictures are included it will help even more
Thanks
Posted: Tue 21 Aug , 2007 21:54 pm
by Triac whizz
No easy answer. Depends on your skill set
seach this site, Davidmurry has done a conversion on a starturn. that will give you a start
Google is your best friend
try Mach 3; gecko; breakout board;
bonne chance
Posted: Fri 24 Aug , 2007 15:10 pm
by kato
Hi,
I ´m almost finished with converting my ORAC. Only the turret is´nt finished. If you have questions I might help you. And cjmerlin here on the forum (he is also on the machsupport forum) helped me alot, so if you ask him he might help you too.
/Jim