Colin.
I've sent you a Private Message (PM).
Orac spindle drive problem
Moderators: Martin, Steve, Mr Magoo
-
MAX THE MILLER
- CNC Expert
- Posts: 152
- Joined: Tue 23 Aug , 2011 18:25 pm
- Hardware/Software: Denford Triac PC. VR Milling 5.51.0.616
-
Ridgeback
- Posts: 33
- Joined: Sat 31 Oct , 2015 21:33 pm
- Hardware/Software: Denford Triac with original hardware/software
Denford Orac recently updated with Mac3 - Location: Redhill, Surrey. U.K.
Re: Orac spindle drive problem - resolution?
Hi All,
I must apologise for not coming back to this post and completing the task I began. I too find it quite frustrating when I read into a possible solution to a problem only to find that you get hung out to dry with no final solution to that problem. I hope to give a more in depth reply at a later date, but for those who are after an instant and concise reply, it all turned out to basically be a failure of the V.F.D. (variable frequency drive) along with a few other smaller issues. I hope this might help point you in a direction which might move your project on in a positive way.
Colin.
I must apologise for not coming back to this post and completing the task I began. I too find it quite frustrating when I read into a possible solution to a problem only to find that you get hung out to dry with no final solution to that problem. I hope to give a more in depth reply at a later date, but for those who are after an instant and concise reply, it all turned out to basically be a failure of the V.F.D. (variable frequency drive) along with a few other smaller issues. I hope this might help point you in a direction which might move your project on in a positive way.
Colin.