Hi guys
Does any one know what newton meters the origenal stepper motors of the Orac are? I cant decide which stepper motors to use on my Orac as I want to replace them. I am battling with the shaft size as I dont want to replace the current pulleys.
Thanks guys
Johann
Orac stepper motors.
Moderators: Martin, Steve, Mr Magoo
-
Calgone
- Posts: 9
- Joined: Thu 19 Jun , 2014 12:30 pm
- Hardware/Software: Solidworks
HSMXpress
Denford Orac
XYZ Milling Machine
Cubex Duo 3D Printer
Re: Orac stepper motors.
Hi,
If I rember correctly they are rated at a low 156Ncm, but with the grearing down via a timing belt on the leadscrew, works quite happily, and the lighter load on the cross slide needs little power to move it.
Hope this helps.
If I rember correctly they are rated at a low 156Ncm, but with the grearing down via a timing belt on the leadscrew, works quite happily, and the lighter load on the cross slide needs little power to move it.
Hope this helps.