Hi!
I tried to power up Orac this morning but, screen only shows horizontal green bands containing half characters. Some of them I can hardly read.
This is very annoying though because the lines are flickering
Has someone ever encountered similar problem?
Could that be a monitor related symptom? In which case, replacing the screen with a good one solves this or is it a more complicated case originating at the computer which sends info to the video module.
If someone has an idea of what might have caused this monitor problem please help.
Orac monitor problem
Moderators: Martin, Steve, Mr Magoo
-
seaman77
- CNC Apprentice
- Posts: 66
- Joined: Mon 19 Apr , 2010 9:18 am
- Hardware/Software: two Triacs one Orac.
- Location: Ellada
Re: Orac monitor problem
Hi!
I tried to power up Orac this morning but, screen only shows horizontal green bands containing half characters. Some of them I can hardly read.
This is very annoying though because the lines are flickering
Has someone ever encountered similar problem?
Could that be a monitor related symptom? In which case, replacing the screen with a good one solves this or is it a more complicated case originating at the computer which sends info to the video module.
If someone has an idea of what might have caused this monitor problem please help.
I tried to power up Orac this morning but, screen only shows horizontal green bands containing half characters. Some of them I can hardly read.
This is very annoying though because the lines are flickering
Has someone ever encountered similar problem?
Could that be a monitor related symptom? In which case, replacing the screen with a good one solves this or is it a more complicated case originating at the computer which sends info to the video module.
If someone has an idea of what might have caused this monitor problem please help.
-
seaman77
- CNC Apprentice
- Posts: 66
- Joined: Mon 19 Apr , 2010 9:18 am
- Hardware/Software: two Triacs one Orac.
- Location: Ellada
Re: Orac monitor problem
...Found fault and restored.
Poor connection to video module.
Poor connection to video module.
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Orac monitor problem
Glad you sorted it..I'll move your other posts to the classifieds section (but leave shadow topics in this Orac section)