Noverturn motor ticking
Moderators: Martin, Steve, Mr Magoo
-
- Posts: 4
- Joined: Fri 07 Nov , 2014 12:06 pm
- Hardware/Software: denford noverturn
Noverturn motor ticking
My noverturn motor is making a ticking noise. But not all the time are the brushes on there way out . Are thay in stock
Re: Noverturn motor ticking
Are you talking about the spindle motor? This will have brushes. The axes motors are steppers and brush free.
-
- Posts: 4
- Joined: Fri 07 Nov , 2014 12:06 pm
- Hardware/Software: denford noverturn
Re: Noverturn motor ticking
Sorry , Yes the spindle moter. It runs all ok just a on and of ticking , worse at faster spindle speeds . thanks
Re: Noverturn motor ticking
Can you you check the drive belt for swarf?
-
- Posts: 4
- Joined: Fri 07 Nov , 2014 12:06 pm
- Hardware/Software: denford noverturn
Re: Noverturn motor ticking
The belt is clean and in good nick . have made 2 - 300 more parts on it some times the ticking stops and then starts again . Thanks